In people’s daily lives, we often hear the saying, “Safety first, prevention paramount.” This clearly shows that safety has become a highly important social issue. Ensuring safety requires the joint efforts of the entire society, but it also depends on each individual’s ability to anticipate and prevent potential hazards. With thorough preparation, we can nip problems in the bud before they even arise. No matter what we’re doing or about to do, we must always keep one thing in mind: safety is of utmost importance. So, when proceeding... Precision metalworking What important safety operating rules should you pay attention to? Let’s find out together below:

1 Safety precautions before entering precision metalworking:

When performing precision metalworking, operators must maintain proper posture and remain fully energized. During operation... It is essential to stay fully focused and refrain from idle chatter. Teamwork and mutual cooperation are crucial. Operators must never operate machinery when feeling irritable or fatigued. For personal safety, to prevent accidents, and to ensure operational security, all employees must check before starting work whether their attire meets the job requirements. Slippers, high heels, and any clothing that could compromise safety are strictly prohibited. Employees with long hair must remember to wear a safety helmet.

2. Precision metalworking Safety precautions to check before starting work:

Before starting the machine, check whether the moving parts have been lubricated. Then, start the machine and verify that the clutch and brake are functioning properly. Finally, run the machine at no-load. 1-3 Minutes—Do not operate the machinery if a malfunction is detected.

3. Precision metalworking Safety precautions to observe during work:

While the machine is in operation, it is strictly prohibited to reach into the slider’s working area with your hands, and it is forbidden to use your hands to pick up or place workpieces. When retrieving or placing workpieces inside the die, you must use tools that meet the required standards. If you notice any unusual noises or malfunctions in the machinery, immediately turn off the power switch and perform a thorough inspection. After the machine has been started, only one person should be responsible for feeding materials and operating the machine; no other personnel are allowed to press the power button or step on the footswitch pedal. For the safety of others, never put your hands into the machine’s working area or touch any moving parts of the machine with your hands.

4 Safety precautions for operating precision metalworking machinery:

You must wait until all other personnel have left the machine’s work area and removed any clutter from the workbench before you can turn on the power and start the machine.

5 Safety precautions to observe when replacing molds during precision metalworking:

When replacing the mold, first turn off the power supply. Once the press’s moving parts have come to a complete stop, you can begin installing and adjusting the mold. After installation and adjustment are complete, manually rotate the flywheel twice to perform test punches. To prevent unnecessary collisions between the machinery and the workpiece, be sure to check that the upper and lower dies are symmetrical and properly aligned, that all screws are securely tightened, and that the pressure ring is positioned correctly.